Designers & Builders of Fine Cedar Wooden Canoes

The Cedar Strip Epoxy Process

All of our canoes are built with the highest standards and care. The following is a short pictorial of How a wood cedar strip and epoxy canoe is built at Carrying Place Canoe Works.


1. Aligning stations on the strongback	2. Bending stems on form

3. Shaping and bevelling inside stem on form	4. Stem installed on stem form, stations taped, and 1st strip installed

5. Installing strips	6. Installing strips

7. Installing strips	8. One side completed

9. Cutting Centre line	10. Fitting outside stem

11. Outside stem installed	12. Fairing hull

13. Sanding hull before fibreglass	14. Outside stem faired
	next page >>>

The Omer Stringer Story

Building of a Cedar Canvas Canoe

• Home Page • About Us • Cedar Canvas Canoes • Cedar Epoxy Canoes • Cedar Motor Rowboat •
• Cedar Rowing Skiff • Plans & Kits • Omer Stringer Paddles • Materials & Accessories •
• Restorations • Contact Carrying Place •

Cedar Strip and Cedar Canvas Canoes
CARRYING PLACE
Canoe & Boat Works Limited
11611 Highway 27, Kleinburg, Ontario, L0J 1C0
Telephone: (905) 893-1350 Fax: (905) 893-3168
E-mail: